User`s guide

Sun StorEdge Network FC Switch-8 and Switch -16 Switch Operations—Switch 3.0 -29
If the port in Zone 1 is connected to A3500FC Disk Array and Zone 2 already
contains at least one A3500FC Disk array, then go to Step 3.
2. Bring down the host in Zone 2.
If the SANSurfer application is running on any other host, you can make the
changes from that application.
If you have the SANSurfer application up and running on any other host, you can go
ahead with the changes from that application. If you have configured only two zones
on the switch and there are no other hosts, bring up the host on the Zone 1 and
launch the SANSurfer application.
3. Add the port to Zone 2.
See SANbox 8/16 Switch Management User’s Manual.
4. Bring up the hosts on Zones 1 and 2.