User`s guide

Sun StorEdge Network FC Switch-8 and Switch -16 Switch Operations—Switch 3.0 -25
The Second Switch
1. Launch the SANsurfer and connect to the switch.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for launching and connecting.
2. Replace the switch.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for replacing the switch.
3. Restore the saved settings.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for restoring the saved settings. The settings restored are from saved configuration
files.
▼ To Replace the Switches When Both Switches Have Had
Catastrophic Failures—Saved Settings
The First Switch
1. Launch the SANsurfer and connect to the switch.
See “To Replace a Switch in a Single-Switch Fabric” on page 18 and follow the steps
for launching and connecting.
Note – Remember that neither switch is functional. You may have to omit one or
more steps.
2. Replace the switch.
See “To Replace a Switch in a Single-Switch Fabric” on page 18 and follow the steps
for replacing the switch.
3. Configure the replacement switch for the Network.
See “To Configure the Network for a Replacement Switch” on page 19.
4. Restore the saved settings.
See “To Replace a Switch in a Single-Switch Fabric” on page 18 and follow the steps
for restoring the saved settings. The settings restored are from saved configuration
files.
The Second Switch
One switch on the network, and you must replace the second switch.