User`s guide

-24 Sun StorEdge network FC switch-8 and switch-16 Operations Guide • August 2001
▼ To Replace the Switches When One of the Switches Within
the Fabric is Responding to the SANsurfer GUI
The First Switch
1. Launch the SANsurfer and connect to the switch.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for launching and connecting.
2. Replace the switch.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for replacing the switch.
3. Restore the saved settings.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for restoring the saved settings. The settings restored are from saved configuration
files.
The Second Switch
1. Launch the SANsurfer and connect to the switch.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for launching and connecting.
2. Replace the switch.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for replacing the switch.
3. Restore the saved settings.
See “To Replace a Switch in a Two-Switch Fabric” on page 14 and follow the steps
for restoring the saved settings. The settings restored are from saved configuration
files.
▼ To Replace the Switches When One of the Switches Is
Responding to the SANsurfer GUI
The Failed Switch
1. See “To Replace a Switch in a Two-Switch Fabric” on page 14.
Perform all the steps in the section, until the catestrophically failed switch has been
replaced.