Installation guide
Table Of Contents
- Contents
- Using UNIX Commands
- Typographic Conventions
- Shell Prompts
- Related Documentation
- Accessing Sun Documentation Online
- Sun Welcomes Your Comments
- New Features
- Features, Benefits, and Products
- SAN 4.0 Device Names
- On-Demand Node Creation
- Fabric Connection of Hosts
- Cascading of Switches
- Higher Realized Bandwidth
- Support of Multiple Protocols
- Support for More, Heterogeneous Storage Devices
- Support for New Hardware and Software
- Software and Hardware Upgrade
- Building Blocks for More Complex Topologies
- Overall Installation Order
- Configuring the Switch Ethernet Port
- Installing SAN Software for the First Time
- Upgrading Existing SAN Software

24 Sun StorEdge SAN 4.0 Release Installation Guide • July 2002
13. Install fcip driver patch 111096-04.
14. Install qlc driver patch 111097-10.
15. Install specfs patch 111588-03.
Patch 111588-03 may have been installed with your operating system. Use the
showrev command to see if has already been installed
16. Install cfgadm plug-in library patch 111846-04.
17. Reboot the system.
For each of the storage devices, upgrade the software, firmware, or configuration.
The components should be upgraded to the revision levels outlined in Table 3-1
“Minimum Software Component Versions and Patches” on page 11.
After performing the above steps, you can leverage additional features provided by
the Sun StorEdge SAN 4.0 Release. You can configure the SAN for:
■ 2 Gb Switches
■ 2 Gb Host Bus Adapters
■ Heterogeneous Switches
■ Large Configuration Support
# patchadd patch-location/111096-04
# patchadd patch-location/111097-10
# patchadd patch-location/
111588-03
# showrev -p | grep 111588
# patchadd patch-location/111846-04