User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Cable Continuity Tests
SANbox-16HA Fibre Channel Switch
3-12 Diagnostics/Troubleshooting 59005-03 Rev. A Installer’s/User’s Manual
Cable Continuity Tests
When there is a problem communicating over a particular link and both the Switch
and the N_Port adapter pass their respective tests, check the continuity of the
cables.
If possible, swap another set of cables into the faulty link.
Did this correct the problem?
Yes Replace the faulty cable.
No Contact your support representative.