User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-16HA Fibre Channel Switch
vi
59005-03 Rev. A Installer’s/User’s Manual
Mesh Latency 5-9
Mesh Bandwidth 5-10
Mesh Physical Distance Between Chassis 5-10
Mesh Zoning 5-11
MKII Compatibility 5-11
Multistage Topology 5-12
T_Port Rules for SANbox IO/T Chassis 5-12
T_Port Rules for SANbox Cross-Connect (CC) Chassis 5-12
Multistage Fabric Size 5-12
Multistage Latency 5-12
Multistage Bandwidth 5-13
Multistage Physical Distance Between Chassis 5-13
Multistage Zoning 5-13
MKII Compatibility 5-13
Multistage Examples 5-14
Cabling 5-17
Fiber Optic T_Port Connections 5-17
Copper T_Port Connections 5-17
T_Port Cable Length 5-17
Device Connections 5-17
Chassis Configuration 5-18
Chassis Configuration Process 5-19
A
Reference Information
QLogic Customer Support A-1
SANbox-16HA Fibre Channel Switch Specifications A-2
Switch A-2
Switch Maintainability A-4
Fabric Management A-4
Switch Mechanical A-5
Switch Electrical A-5
Switch Environmental A-5
Switch Regulatory Certifications A-6
Shortwave Laser GBIC (multi-mode) A-6
Longwave Laser GBIC (single-mode) A-7
Copper Inter-Enclosure GBIC (active) A-7
Copper Intra-Enclosure GBIC (passive) A-8