User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Chassis Back
SANbox-16HA Fibre Channel Switch
Installer’s/User’s Manual 59005-03 Rev. A General Description 1-23
Chassis Back
Refer to Figure 1-8. The back of the chassis contains bays for two Power Supplies.
The fan is part of the power supply. Air enters the front of the chassis and exits the
back of the chassis.
Figure 1-8 Chassis Back
Power Good Light
(Green)
Over Temperature
Light (Red)
Optional Power
Supply Bay
Cover Plate (no second
power supply)
Power Supply
Locking Screws
Fan