User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
Switch Management Tools
SANbox-16HA Fibre Channel Switch
1-16 General Description 59005-03 Rev. A Installer’s/User’s Manual
• Set or read the IP network configuration
• Read the SNMP configuration information
• Online testing
Trivial File Transfer Protocol (TFTP)
The following functions are available in TFTP:
• Load switch firmware
• Modify configuration parameters
Simple Network Management Protocol (SNMP)
SNMP enables you to read management information from the switch.