User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-16HA Fibre Channel Switch
Installer’s/User’s Manual 59005-03 Rev. A General Description 1-1
Section 1 General Description
Introduction
The SANbox™-16HA High Availability Fibre Channel (FC) Switch is the Fabric
component of a Fibre Channel compliant network. Figure 1-1 is an illustration of
the Switch. This manual describes the Switch as a full-featured fabric Switch
unless otherwise specified.
Figure 1-1 SANbox-16HA Fibre Channel Switch