User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index

Preliminary
Index
SANbox-16HA Fibre Channel Switch
Installer’s/User’s Manual 59005-03 Rev. A Index 5
private targets 1-8, 2-19
public initiator 1-6
public targets 1-8
topologies supported 1-6
translation entries list 1-8, 2-19
zoning 1-8
topology
cascade 5-5
choosing 5-3
mesh 5-9
mixing 5-4, 5-8, 5-11
Multistage 5-12
Traffic LED 1-22
translated loop example 2-16
Translated Loop Port - See TL_Port.
translation 1-6
Trivial File Transfer Protocol 1-16
troubleshooting
cable continuity 3-12
power supply 3-6
Trunk Port - See T_Port.
tuning ports 2-20
U
unpack 2-1
user interface A-4
V
VCCI - See Voluntary Control Council for Interference.
vibration A-5
voltage
fluctuations A-6
operating A-5
W
Warning 4-7
warning notice 1-3
world wide name 1-13, 2-21, 5-4, 5-20
WWN - See World Wide Name
Z
zone
broadcast 1-12, 2-22
hard 1-12, 2-21
Name Server 1-12, 1-13, 2-21
segmented loop 1-13, 2-18, 2-21
zoning
cascade 5-8
description 2-21
mesh 5-11
multistage 5-13