User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-16HA Fibre Channel Switch Specifications
SANbox-16HA Fibre Channel Switch
A-4 Reference Information 59005-03 Rev. A Installer’s/User’s Manual
Switch Maintainability
Maintenance Strategy: .......................FRU-based:
GBIC Modules
Power supplies/fans
AC input fuses
Does not require enclosure opening for any
reason, including:
GBIC insertion to populate/activate
new ports
GBIC replacement
Redundant power supply replacement
Does not require system interruption for:
GBIC insertion to populate/activate
new ports
GBIC replacement
Redundant power supply replacement
Backup Components:.........................Hot-swappable spare power supply and
integral cooling fan. Redundant Power
Cables and Input Fuses)
Diagnostics:........................................Power-On-Self-Test (POST) tests all
functionality except media modules.
Field selectable Continuous Test tests all
functionality including media modules.
Fabric Management
Fabric Management:...........................Simple Name Ser ver, Alias Ser ver, SNMP,
the SANsurfer Web-based Java application,
and Telnet
User Interface:....................................LED indicators
Maintenance Interface: ......................Ethernet 10/100 BASE-TEthernet
Connector:..........................................RJ-45