User`s guide

2 – QLA2310/2310F/2310FL
FCode
FC2354601-00 E 2-9
Q
The new data rate displays. For example:
Calculating NVRAM checksum, please wait...
Current HBA data rate: Two Gigabit rate
Possible data rate choices:
0 - One Gigabit rate
1 - Two Gigabit rate
2 - Auto-negotiated rate
QLogic recommends the Auto-negotiated rate (2), which works for most
devices.
2.3.5
Selecting the Boot Device
Perform the following steps to select a Fibre Channel device that is attached to the
QLA23xx HBA as the boot device:
1. Use the show-devs command to display the device tree for all devices attached
to the machine.
ok show-devs
The device tree displays. The QLA23xx HBAs with FCode are referenced with
QLGC,qla@. For example:
ok show-devs
.
.
/pci@1f,0/pci@1/QLGC,qla@4
2. Select the QLA23xx HBA attached to the Fibre Channel device from which you
want to boot. For example, type the following at the ok prompt:
" /pci@1f,0/pci@1/QLGC,qla@4" select-dev
3. Use the show-children command to view the devices attached to the QLA23xx
HBA. For example:
ok show-children
4. The list of devices displays. Write down the boot device’s world wide name
(WWN), loop ID, and logical unit number (LUN).
5. Save the boot device information to the QLA23xx HBA’s NVRAM. Use the
set-boot-id command. Include the selected QLA23xx HBA’s WWN, loop ID,
and LUN. For example:
ok 2200002037009eeb 82 0 set-boot-id