User`s guide

2 – QLA2310/2310F/2310FL
FCode
2-8 FC2354601-00 E
Q
2.3.3
Setting the QLA23xx HBA Loop ID
When the QLA23xx HBA is currently operating in loop mode (through connection
mode 0 or connection mode 2), perform the following steps to view its loop ID and
change it if necessary:
1. Select the QLA23xx HBA attached to the Fibre Channel device from which you
want to boot. For example, type the following at the ok prompt:
" /pci@1f,0/pci@1/QLGC,qla@4" select-dev
2. To view the loop ID, type the show-adapter-loopid command.
ok show-adapter-loopid
The loop ID displays. For example:
Adapter loopid - 7c
3. If the loop ID is not correct, change it using the set-adapter-loopid command.
For example:
ok 0 set-adapter-loopid
The new loop ID displays. For example:
Adapter loopid - 0
2.3.4
Setting and Viewing the Fibre Channel Data Rate
Use the show-data-rate command to view the current QLA23xx Fibre Channel data
rate. For example:
1. Select the QLA23xx HBA attached to the Fibre Channel device from which you
want to boot. For example, type the following at the ok prompt:
" /pci@1f,0/pci@1/QLGC,qla@4" select-dev
2. Type the following:
ok show-data-rate
3. The current data rate displays. For example:
Current HBA data rate: One Gigabit rate
Possible data rate choices:
0 - One Gigabit rate
1 - Two Gigabit rate
2 - Auto-negotiated rate
Use the set-data-rate command to change the current QLA23xx Fibre Channel
data rate. For example:
ok 1 set-data-rate