User`s guide

SANblade 2300 Series User’s Guide
2-Gb Fibre Channel to PCI-X Host Bus Adapters
Q
FC2354601-00 E Page iii
Clarified description of the following QLA2300.HAM parameters:
/SKIPREPORT
/INQUIRY
/COMPLEXTAG
/QUALIFIED
11.5.1
Clarified description of /INQUIRY QLA2300.HAM parameter 11.5.1
In Fast!UTIL Host Adapter Settings, corrected the valid values for the Loop
Reset Delay setting
The following settings were moved from the Extended Firmware Settings
menu, which has been removed:
Connection Options
Fibre Channel Tape Support
Data Rate
11.5.2, 14.2.1
Removed the following Fast!UTIL Advanced Adapter Settings:
>4GByte Addressing
IOCB Allocation
Added the following Fast!UTIL Advanced Adapter Settings:
Link Down Timeout
Memory Mapped Access
Changed the default for the Port Retry Count setting to 30.
Changed definition of Extended Error Logging setting.
The following settings were moved from the Extended Firmware Settings
menu, which has been removed:
RIO Operation Mode
Interrupt Delay Timer
11.5.2, 14.2.5
The Extended Firmware Settings menu has been removed from Fast!UTIL;
the parameters have moved to other menus
was 14.2.6, 11.5.2
Corrected command text for building the Red Hat driver from the source
code
12.3.2.1
Corrected command text to load Red Hat Driver manually 12.3.2.3
Added more information about pre-installation requirements for the Solaris
driver
13.2.1