User`s guide

19 – SANblade Control VIX Application for Windows 2000
Main Window and Window Navigation
FC2354601-00 E 19-7
Q
If you selected the Launch Application check box in step 9, the SANblade
Control VIX main window displays. The Install Complete dialog box is also
displayed; it may be behind the main window.
11. If you did not run SANblade Control iX in step 9, perform the following steps to
run SANblade Control iX: click Start, select Programs, select the install group
(the default is QLogic Corporation), then click SANblade Control VIX.
19.3
Getting Started
To launch the SANblade Control VIX Application, from the Start menu, select
Programs, select QLogic Corporation, then click SANblade Control VIX.
19.4
Exiting SANblade Control VIX
Perform one of the following steps to exit the SANblade Control VIX Application:
n From the SANblade Control IX main window File menu, select Exit.
n Click the Close button in the upper-right hand corner of the screen.
19.5
Main Window and Window Navigation
This section provides an overview of the SANblade Control VIX Application,
including how to navigate through the screens and tabbed pages. The purpose of
each screen is described. See sections 19.6 through 19.9 for information on using
SANblade Control VIX to view and configure the HBAs.