User`s guide

18 – SANblade Control FX Wizard for Windows NT/ Windows 2000
Configuring HBAs in SANblade Control FX Wizard
FC2354601-00 E 18-7
Q
n The Enable column contains a check box denoting whether a target is configured
in the operating system.
By selecting or clearing this check box, you can
select the port state (visible/hidden/unconfigured).
n The Type column contains the target type (disk or tape).
n The Node Name column contains world wide node name of the target.
n The Port Name column contains the world wide port name of the target.
n The Target ID column allows you to specify a target ID for the port.
n The State column contains the state of the port (visible/hidden/unconfigured).
For a detailed description of how targets are persistently bound, see section 17.7.2.
After binding the targets, click Next.
18.4.6
Confirm Configuration Changes
After binding the targets, the Confirm Changes screen displays (see figure 18-6).
Figure 18-6. Confirm Changes Screen
The Confirm Changes screen shows all the settings for the HBA specified in the
middle portion (white) of the screen.