User`s guide

18 – SANblade Control FX Wizard for Windows NT/ Windows 2000
Configuring HBAs in SANblade Control FX Wizard
18-6 FC2354601-00 E
Q
Select the data rate. The following options are available:
n 1 Gbps. The HBA runs at 1 Gbps. (This is the default setting.)
n 2 Gbps. The HBA runs at 2 Gbps.
n Auto negotiate. The system determines what rate it can accommodate and sets
it accordingly.
After making selecting the HBA connections settings, press Next.
18.4.5
Perform Target Binding
After selecting the HBA connection settings, the Target Configuration screen
displays (see figure 18-5).
Figure 18-5. Target Configuration Screen
This screen displays the host name, HBA model, node name, and port name of the
selected HBA. The screen allows you to configure the targets connected to the
current HBA.
The targets connected to the HBA are displayed in a table. Each row in the table
corresponds to one port of a target device. The following information about each
target device is displayed in the table: