User`s guide

18 – SANblade Control FX Wizard for Windows NT/ Windows 2000
Configuring HBAs in SANblade Control FX Wizard
FC2354601-00 E 18-5
Q
n Firmware version
n Failover driver version (if failover driver QLdirect is installed)
After verifying the HBA and driver information, press Next.
18.4.4
Update the HBA Connection Settings
After verifying the HBA and driver information, the HBA Connection Settings
screen displays (see figure 18-4).
Figure 18-4. HBA Connection Settings Screen
Define the type of connection you want to use when the system boots. The following
options are available:
n Loop Only
n Point to Point Only
n Loop Preferred, Else Point to Point (default)