User`s guide

18 – SANblade Control FX Wizard for Windows NT/ Windows 2000
Configuring HBAs in SANblade Control FX Wizard
FC2354601-00 E 18-3
Q
18.4.1
Review the Configuration Process
When you launch SANblade Control FX in wizard mode, the QLogic Configuration
Wizard screen displays (see figure 18-1).
This screen displays the QLA23xx HBAs on the local system. This screen is for
your information (you cannot select an HBA). To continue the configuration process,
click Next. To end the configuration process, click Cancel.
18.4.2
Select an HBA to Configure
If you click Next, the HBA Selection screen displays (see figure 18-2).
Figure 18-2. HBA Selection Screen
The following information is shown for each HBA:
n Port name. World wide port name of the HBA
n Node name. World wide node name of the HBA
n HBA model
n Configured. If this HBA has been configured using the SANblade Control FX
Wizard, this column displays Yes. If this HBA has not been configured, this
column displays No.