User`s guide

17 – SANblade Control FX Application for Windows NT/ Windows 2000
Configurating the HBA
17-26 FC2354601-00 E
Q
17.7.2
Bind Target Devices Attached to the HBAs
Bind target devices to the attached HBAs using the Target Settings tabbed page.
To access the Target Settings tabbed page, perform the following steps:
1. Click an adapter in the HBA tree on the left side of the screen. The HBA tabbed
pages are displayed on the right side of the screen.
2. Click the Target Settings tab.
The Target Settings tabbed page is shown in figure 17-18.
Figure 17-18. Target Settings Tabbed Page
Target persistent binding in Windows NT/Windows 2000 is done by selecting a port
state (discussed in this section) and specifying the target ID.