User`s guide

17 – SANblade Control FX Application for Windows NT/ Windows 2000
Configurating the HBA
FC2354601-00 E 17-25
Q
q Multiple responses, 16-bit handles, delay host interrupt
q Multiple responses, 32-bit handles, delay host interrupt
n Enable Adapter Hard Loop ID. Select this check box to force the HBA to attempt
to use the ID specified in the Hard Loop ID option. By default, the Enable
Adapter Hard Loop ID check box is cleared.
n Enable LIP Full Login. Select this check box for the ISP chip to re-login to all
ports after any loop initialization process (LIP). By default, this check box is
cleared.
n Hard Loop ID. If you selected Enable Adapter Hard Loop ID, the HBA attempts
to use the ID specified in this option. The default ID is 0. Enter an ID in the
range 0–125.
n Login Retry Count. This setting specifies the number of times the software tries
to log in to a device. The default is 8 retries. Enter a value in the range 0–255.
n Interrupt Delay Timer. This setting contains the value (in 100-microsecond
increments) used by a timer to set the wait time between accessing (DMA) a set
of handles and generating an interrupt. The default is 0. Enter a value in the
range 0–255.
After configuring the Advanced Firmware Parameters, click one of the buttons at
the bottom of the page to save the new configuration (see section 17.7.1).