User`s guide

17 – SANblade Control FX Application for Windows NT/ Windows 2000
Configurating the HBA
17-24 FC2354601-00 E
Q
n Extended Logging. When you select this check box, additional error and debug
information is provided to the operating system. Events are logged into the Event
Viewer.
After configuring the Advanced Host Parameters, continue with another selection
(Host Parameters or Advanced Firmware Parameters), or click one of the buttons
at the bottom of the page to save the new configuration (see section 17.7.1).
17.7.1.3
Advanced Firmware Parameters
This part of the HBA Options tabbed page contains firmware parameter settings
that you can update to tune or troubleshoot a support issue (see figure 17-17).
Figure 17-17. HBA Options Tabbed Page (Advanced Firmware Parameters)
The advanced firmware parameters are described in the following paragraphs:
n RIO Mode. This setting specifies the reduced interrupt operation (RIO) modes,
if supported by the software driver. RIO modes allow posting multiple command
completions in a single interrupt. The default is No Multiple Responses. Select
one of the following options from the drop-down list:
q Multiple responses, 16-bit handles, interrupt host
q Multiple responses, 32-bit handles, interrupt host