User`s guide

17 – SANblade Control FX Application for Windows NT/ Windows 2000
Configurating the HBA
FC2354601-00 E 17-19
Q
17.6.2
Displaying HBA Information
Click on an adapter model in the HBA tree on the left side of the screen to display
the read-only HBA Information tabbed page (see figure 17-2). The page displays
basic information about an HBA.
This read-only page displays the following information:
n Serial number
n Driver version
n BIOS version
n Firmware version
n Failover driver version (if failover driver QLdirect is installed)
17.6.3
Displaying Target and LUN Information
Click on a target device in the HBA tree on the left side of the screen to display the
target Information tabbed page (see figure 17-12) and the LUN List tabbed page
(see figure 17-13).
The read-only target Information tabbed page displays information for the selected
device in the HBA tree, including the vendor, product ID, product revision, target
node name, target port name, and target port ID.
The read-only LUN List tabbed page contains the same information as the target
Information tabbed page, as well as a list of all the LUNs attached to the device.
The following information is displayed for each LUN:
n LUN ID
n Vendor
n Product ID
n Product revision
n World wide LUN name
n LUN size (in GB)
Another way to display LUN information is to click a LUN in the HBA tree, which
displays the LUN Information tabbed page (see figure 17-14). This page contains
the same information as the LUN List tabbed page, but in a tabular format that
includes all LUNs under the device.
17.7
Configurating the HBA
This section describes how to use the SANblade Control FX Application to do the
following:
n Configure HBAs (see section 17.7.1)
n Bind devices attached to the HBAs (see section 17.7.2)