User`s guide

16 – SANblade Control FX Wizard for Solaris

Configuring HBAs in SANblade Control FX Wizard

FC2354601-00 E 16-9

16.4.8

Exit Wizard Mode

If you selected the No radio button from the HBA Configuration Status screen

and clicked the Next button, the Exit Wizard screen displays (see figure 16-8).

Figure 16-8. Exit Wizard Screen

Select one of the following options by clicking the option button, then click the Finish

button:

n Exit Wizard. This option exits SANblade Control FX. You need to restart your

computer for the configuration changes to take effect.

n Exit Wizard, run Advanced Utility. This option exits the SANblade Control FX

Wizard and runs (or returns to) the SANblade Control FX Application. Select this

option if you want to configure advanced HBA features. Changes made with the

SANblade Control FX Wizard and SANblade Control FX Application will not take

effect until you restart the computer.

n Exit Wizard, reboot machine with --r option. This option exits the SANblade

Control FX Wizard and the SANblade Control FX Application. The system is

restarted with the --r option for the configuration changes to take effect.

n Exit Wizard, reboot machine with command typed below. This option exits

the SANblade Control FX Wizard and the SANblade Control FX Application. The

system is restarted with option you type in the selection box.