User`s guide

16 – SANblade Control FX Wizard for Solaris
Screen Navigation
16-2 FC2354601-00 E
Q
16.3
Screen Navigation
When you launch the SANblade Control FX Wizard, the QLogic Configuration
Wizard screen displays (see figure 16-1).
Figure 16-1. QLogic Configuration Wizard Screen
The following buttons are available on all screens:
n Cancel. To end the configuration process at any time, click the Cancel button.
n Back. To go back through the previous screens, click the Back button.
n Help. For online help, click the Help button.
16.4
Configuring HBAs in SANblade Control FX Wizard
The following sections describe, step by step, how to configure your HBAs with
SANblade Control FX Wizard.
16.4.1
Review the Configuration Process
When you launch SANblade Control FX in wizard mode, the QLogic Configuration
Wizard screen displays (see figure 16-1).
This screen displays the QLA23xx HBAs on the local system. This screen is for
your information (you cannot select an HBA). To continue the configuration process,
click the Next button. To end the configuration process, click the Cancel button.