User`s guide

FC2354601-00 E 16-1
Section 16
SANblade Control FX Wizard for Solaris
16.1
Introduction
The SANblade Control FX Wizard provides step-by-step procedures to configure a
common set of HBA options for all the QLA22xx and 23xx HBAs installed on the
local machine.
Make sure you have installed the SANblade Control FX (see section 15.2) before
running the SANblade Control FX Wizard.
Throughout this section, HBA and adapter are used interchangeably. Some screens
in the GUI use HBA, some use adapter. Both refer to the QCP/QSB22xx and 23xx.
16.2
Getting Started
Perform the following steps to launch the SANblade Control FX Wizard.
If the SANblade Control FX Application is not running, do the following:
1. Change (cd) to the SANblade_Control_FX directory.
2. Type the following:
# scfx --wiz
If the SANblade Control FX Application is running, point to Tools on the menu bar,
then select Run Wizard.