User`s guide

15 – SANblade Control FX Application for Solaris

Configurating the HBA

FC2354601-00 E 15-25

n Enable ACK0. This setting determines the type of ACK used. Select this check

box to use sequence ACK. Clear this check box to use frame ACK. The default

is disabled.

NOTE: If you select Enable ACK0, you must also select Enable Class 2

Service.

n Enable Read Transfer Ready. This option is reserved. By default, this check

box is cleared.

n Hard Loop ID. If you selected Enable Adapter Hard Loop ID, the HBA attempts

to use the ID specified in this option. The default ID is 0. Enter an ID in the

range 0–125.

n Login Retry Count. This setting specifies the number of times the software tries

to log in to a device. The default is 8 retries. Enter a value in the range 0–255.

n Interrupt Delay Timer. This setting contains the value (in 100-microsecond

increments) used by a timer to set the wait time between accessing (DMA) a set

of handles and generating an interrupt. The default is 0. Enter a value in the

range 0–255.

After configuring the Advanced Firmware Parameters, continue with another

selection (Host Parameters or Advanced Host Parameters), or click one of the

buttons at the bottom of the page to save the new configuration (see section 15.6.1).