User`s guide

15 – SANblade Control FX Application for Solaris
Configurating the HBA
FC2354601-00 E 15-19
Q
The top of the HBA Options tabbed page contains is read-only; it displays
information about the selected adapter. Select one of the following options from the
Select Parameter Section drop-down list:
n Host Parameters
n Advanced Host Parameters
n Advanced Firmware Parameters
These parameters are described in the following sections.
After configuring the parameters in the HBA Options tabbed pages, click one of the
following buttons:
n Save. Saves the values in all three parameter sections.
n Current. Restores the three section's settings to the last saved state.
n Initial. Restores the following settings to their values when the SANblade Control
FX Application was first started:
q Host Parameters:
q Connection Options
q Port Down Retry Count
q Frame Size
q Execution Throttle
q Enable Fibre Channel Tape Support
q Enable Fibre Channel Confirm
q Advanced Host Parameters:
q Enable Target Reset
q Enable Fast Command Posting
q Enable 4GB Addressing
q Maximum LUNS per Target
q Advanced Firmware Parameters:
q Enable Adapter Hard Loop ID
q Enable LIP Full Login
q Enable Class 2 Service
q Enable ACK0
q Enable Read Transfer Ready
q Hard Loop ID
q Login Retry Count
q Interrupt Delay Timer
q Operation Mode
In the following sections, when referring to options that are selected by a check box,
selected means enabled; cleared means disabled.