User`s guide

15 – SANblade Control FX Application for Solaris

Configurating the HBA

15-18 FC2354601-00 E

Another way to display LUN information is to click on a LUN in the HBA tree, which

displays the LUN Information tabbed page (see figure 15-14). This page contains

the same information as the LUN List tabbed page.

15.5.4

Displaying Boot Device Information

Perform the following steps to display information about the boot device for this host:

1. In the main window, click an adapter in the HBA tree. The HBA tabbed pages

display on the right side of the screen.

2. Click the Boot Device tab (see figure 15-7).

This read-only tabbed page contains the following information:

n HBA node name

n HBA port name

n Boot device node name

n Boot device port name

n Boot device LUN ID

n Boot device ID

NOTE: Only one boot device per host can be defined. Therefore, the same boot

device information appears for all HBAs.

15.6

Configurating the HBA

This section describes how to use the SANblade Control FX Application to do the

following:

n Configure HBAs (see section 15.6.1)

n Bind devices attached to the HBAs (see section 15.6.2)

n Perform loopback and read/write buffer tests (see section 15.6.3)

n Update the NVRAM and FCode (see section 15.6.4)

15.6.1

Configure the HBAs

Configure the HBAs using the HBA Options tabbed page. To access the HBA

Options tabbed page, perform the following steps:

1. Click an adapter in the HBA tree on the left side of the screen. The HBA tabbed

pages are displayed on the right side of the screen.

2. Click the HBA Options tab.