User`s guide

14 – Fast!UTIL

Configuration Settings

FC2354601-00 E 14-5

n Execution Throttle. This setting specifies the maximum number of commands

executing on any one port. When a port’s execution throttle is reached, no new

commands are executed until the current command finishes executing. The valid

options for this setting are 1–256. The default is 16.

n LUNs per Target. This setting specifies the number of LUNs per target. Multiple

LUN support is typically for RAID boxes that use LUNs to map drives. The default

is 8. If you do not need multiple LUN support, set the number of LUNs to 0.

n Enable LIP Reset. This setting determines the type of loop initialization process

(LIP) reset that is used when the operating system initiates a bus reset routine.

When this setting is Yes, the driver initiates a global LIP reset to clear the target

device reservations. When this setting is No, the driver initiates a global LIP reset

with full login. The default is No.

n Enable LIP Full Login. This setting instructs the ISP chip to re-login to all ports

after any LIP. The default is Yes.

n Enable Target Reset. This setting enables the drivers to issue a Target Reset

command to all devices on the loop when a SCSI Bus Reset command is issued.

The default is No.

n Login Retry Count. This setting specifies the number of times the software tries

to log in to a device. The default is 8 retries.

n Port Down Retry Count. This setting specifies the number of seconds the

software retries a command to a port returning port down status. The default

is 30 seconds.

n Link Down Timeout. This setting specifies the number of seconds the software

waits for a link to come up. The default is 30 seconds.

n Extended Error Logging. This setting provides additional error and debug

information to the operating system. The default is Disabled.

Port Down Retry Count 0–255 30

Link Down Timeout 0–255 30

Extended Error Logging Enabled, Disabled Disabled

RIO Operation Mode 0, 5, 6 0

Interrupt Delay Timer 0–255 0

Enable BIOS Memory Map I/O Yes, No No

Table 14-3. Advanced Adapter Settings (Continued)

Setting Options Default