User`s guide

11 – NetWare Driver Installation
Driver Parameters
FC2354601-00 E 11-9
Q
11.5.2
NVRAM Parameters
The QLogic HBA NVRAM settings are modified by entering Fast!UTIL during the
QLA23xx HBA BIOS initialization. Table 11-2 lists the settings and how they affect
the NetWare driver.
/LUNZERO Instance This parameter reports LUN 0 to NetWare, even if there
was no response to the SCSI Inquiry command (as long
as the port was logged in). This parameter is used for
RAID subsystems that do not report any LUNs on a port
until the subsystem is configured for the first time.
/LUNZERO parameter example:
LOAD QL2x00.HAM SLOT=3 /ALLPATHS /LUNZERO
Table 11-2. NVRAM Parameters
Setting Used by Driver
Default Value;
Do Not Change
Not Used by
Driver (Change
Has No Effect)
Host Adapter Settings
Host Adapter BIOS 4
Frame Size 4
Loop Reset Delay 4
Adapter Hard Loop ID 4
Spin Up Delay 4
Hard Loop ID 4
Connection Options 4
Fibre Channel Tape Support 4
Data Rate 4
Advanced Adapter Settings
Execution Throttle 4
Luns per Target 4
Enable LIP Reset 4
Enable LIP Full Login 4
Enable Target Reset 4
Login Retry Count 4
Port Down Retry Count 4
Link Down Timeout 4
Table 11-1. QL2300.HAM Driver Parameters (Continued)
Parameter Type Description