User`s guide

11 – NetWare Driver Installation
Driver Parameters
FC2354601-00 E 11-7
Q
/BACKOFF Global This parameter disables failback of I/O after a broken link
or a broken port has been restored and made operational.
/BACKOFF parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS/BACKOFF
/IGNCFG Global This parameter avoids reading the configuration file
QL2x00.CFG, and allows all devices to be reported to
NetWare. The QL2X00.CFG file is located in the default
DOS directory (C:\NWSERVER); this file is written by
QLogic SANsurfer software or the CFG.NLM test tool.
/IGNCFG parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /IGNCFG
/REQCFG Global This parameter requires reading the configuration file
QL2x00.CFG. All devices not specified in this file are
ignored. If this file does not exist, all devices are ignored.
The QL2x00.CFG file is located in the default DOS
directory (C:\NWSERVER); this file is written by QLogic
SANsurfer software or the CFG.NLM test tool.
/REQCFG parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /REQCFG
/CONSOLE Global This parameter sends system alerts to the server console
when failover and failback events occur.
/CONSOLE parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /CONSOLE
/MAXLUNS=n Global This parameter sets the maximum number of LUNs
allowed during the LUN scan. The range of LUNs
searched is 0 to (n – 1).
/MAXLUNS parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /MAXLUNS=256
/SKIPREPORT Instance This parameter avoids executing the SCSI Report LUNs
command during LUN scanning. Omitting this parameter
allows the driver to use the response from the SCSI
Report LUNS command to optimize the LUN scan by
performing SCSI Inquiry commands only to LUNs listed
in the response.
/SKIPREPORT parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /SKIPREPORT
Table 11-1. QL2300.HAM Driver Parameters (Continued)
Parameter Type Description