User`s guide

11 – NetWare Driver Installation
Installing the Driver
FC2354601-00 E 11-3
Q
4. Follow the standard NetWare instructions to begin the installation.
When prompted, select the Custom install option. Do not select the Express
option, which loads the QLogic HAM driver from the NetWare CD.
5. When the driver screen containing the Storage Adapters: label displays, select
the field next to the label and press ENTER.
6. Press INSERT to add a driver. Press INSERT again to add an unlisted driver.
(Do not press ENTER, which loads the driver from the NetWare CD.)
7. Insert the driver disk created in section 11.2 and press F3 to specify the path
to the QLogic HAM driver:
A:\NETWARE
8. Press ENTER to select the QLogic HAM driver.
9. Follow the standard NetWare installation procedure and complete the
installation.
11.3.2
Initial Installation of NetWare and the NetWare Driver (QLA23xx HBA
Connects to an Add-On Device)
To initially install Netware and the NetWare driver on an FC device that is not
attached to the QLA23xx HBA, use Fast!UTIL to disable the QLA23xx BIOS (see
section 14.2.1), then continue with step 2 in section 11.3.1.
11.3.3
Installing the NetWare Driver (Operating System Already Installed)
Perform the following steps to add the NetWare driver to the existing NetWare
system:
1. If you are installing NetWare version 4.2, perform the following steps.
Otherwise, continue to step 2.
a. Create directory NWUPDATE at the root of the C: drive.
b. Copy the NWPA.NLM file from Support Pack 9 (or later) to directory
NWUPDATE on the C: drive.
During installation, NetWare version 4.2 will use the NWPA.NLM from the
NWUPDATE directory instead of the one on the CD-ROM.
2. From the NetWare server prompt, load the appropriate NetWare program:
LOAD INSTALL (NetWare 4.x)
LOAD NWCONFIG (NetWare 5.x, 6.x)
3. Select Driver options from the main menu.
4. Select Configure disk and storage device drivers.