User`s guide

9 – Windows 2000 Driver Installation

QL2x00IP NDIS Network Driver Installation

FC2354601-00 E 9-11

11. Click OK.

12. In the Network Adapter list, click QLogic QLA2X00 PCI Adapter, then click

Next.

13. In the Start Hardware Installation dialog box, click Next to install the driver.

14. If the Digital Signature Not Found dialog box displays, click Yes.

15. In the Add/Remove Hardware Wizard dialog box, click Finish to complete the

driver installation.

16. Modify the IP address parameters and driver parameters. See section 9.7.3 for

details.

9.7.2

Updating the QL2x00IP NDIS Network Driver

Perform the following steps if a QL2x00IP NDIS network driver is already installed

and you want to install an updated version of the driver:

1. Open a DOS command prompt window.

2. Change the current directory to the Windows 2000 driver directory. For

example:

cd \Winnt\System32\Drivers

3. Make a backup copy of the old driver. You can copy the file into the same

directory with a .SAV extension indicating that it is the saved file. For example:

copy Ql2x00ip.sys Ql2x00ip.sav

4. Insert the disk that contains the updated QLogic driver in an appropriate drive.

5. Copy the new driver over the old driver. For example:

copy A:\W2k\Ip\Ql2x00ip.sys

6. Remove the disk that contains the QLogic driver.

7. Restart your system to load the updated driver.

9.7.3

QL2x00IP NDIS Driver Configuration

You must configure the IP address and modify the driver parameters during the

initial installation (see section 9.7.1). You can also modify these later as appropriate

using the following procedures.