User`s guide

9 – Windows 2000 Driver Installation
Windows 2000 Installation
FC2354601-00 E 9-3
Q
9.3.2
Initial Installation of Windows 2000 and the Windows 2000 Driver
(QLA23xx HBA Connects to an Add-on Device)
Perform the following steps to install Windows 2000 and the Windows 2000 driver
on a device that is not attached to the QLA23xx HBA:
1. Start Windows installation procedure using the Windows 2000 Setup disks or
CD.
2. Windows detects the newly installed device, then displays the Found New
Hardware with SCSI controller message. The Found New Hardware Wizard
program is launched to begin installing the QL2300.SYS driver for the QLA23xx
HBA.
3. Click Next.
4. Select Search for a suitable driver for my device (recommended). Click
Next.
5. Scroll down the Hardware types list, select SCSI and RAID controllers and
click Next.
6. Insert the driver disk created in section 9.2 and click Have Disk.
7. On the Install From Disk dialog box, type the following:
A:\
Click OK.
8. Click Next.
9. On the Start Device Driver Installation dialog box, click Next.
10. When the Digital Signature Not Found dialog box displays, select Yes.
11. Click Finish on the Upgrade Device Driver Wizard/Completing the Upgrade
Device Driver Wizard dialog box.
12. The following message displays:
Your hardware settings have changed. You must restart your
computer for these changes to take effect. Do you want to
restart your computer now?
Click Yes.