User`s guide

3 – QLA2340/2340L
QLA2340/2340L HBA Components
3-2 FC2354601-00 J
Q
3.1.1
LEDs
Figure 3-2 identifies and describes the activity of the QLA2340/2340L HBA LEDs.
For more information about the beacon LED activity, see the SANsurfer Applications
User’s Guide (FS0054601-00).
Figure 3-2. QLA2340/2340L HBA LED Activity
3.1.2
Jumpers
The jumpers on the QLA2340/2340L HBAs set the default state of the laser and are
set at the factory with a jumper plug on pins 2–3 of the J3 jumper.
CAUTION!
Changing the jumper settings can result in the HBA being inoperable.
3.1.3
Bracket
The QLA2340 is shipped with an optional low-profile bracket. The QLA2340L is
shipped with an optional full-height bracket. This section describes how to change
the bracket.
CAUTION!
The QLA2340/2340L HBA contains parts that can be damaged by ESD.
Before handling the QLA2340/2340L HBA, use standard methods to
discharge static electricity. Keep the QLA2340/2340L HBA in the
antistatic bag until you are ready to install it. Place the HBA on the bag
when you examine or configure it. Retain the bag for future use.
Green LED Amber LED Activity
Off Off Power off
On On Power
On Off Online
Off On Link established
Off Flashing twice per
second
Loss of
synchronization
Alternate flashing
twice per second
Alternate flashing
twice per second
Firmware error
Off Flashing once per
second
Beacon
GREEN LED
AMBER LED
J1 CONNECTOR
J1 CONNECTOR LEDs