User`s guide

11 – NetWare Driver Installation
Driver Parameters
FC2354601-00 J 11-7
Q
/FAILBACK=n Global This parameter sets the failback delay time period to
n seconds. This is the time period that elapses when a
port update event has occurred before any attempt is
made to failback paths/ports.
/FAILBACK parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /FAILBACK=n
/BACKOFF Global This parameter disables failback of I/O after a broken link
or a broken port has been restored and made operational.
/BACKOFF parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS/BACKOFF
/IGNCFG Global This parameter avoids reading the configuration file
QL2x00.CFG, and allows all devices to be reported to
NetWare. The QL2X00.CFG file is located in the default
DOS directory (C:\NWSERVER); this file is written by
QLogic SANsurfer software or the CFG.NLM test tool.
/IGNCFG parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /IGNCFG
/REQCFG Global This parameter requires reading the configuration file
QL2x00.CFG. All devices not specified in this file are
ignored. If this file does not exist, all devices are ignored.
The QL2x00.CFG file is located in the default DOS
directory (C:\NWSERVER); this file is written by QLogic
SANsurfer software or the CFG.NLM test tool.
/REQCFG parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /REQCFG
/CONSOLE Global This parameter sends system alerts to the server console
when failover and failback events occur.
/CONSOLE parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /CONSOLE
/MAXLUNS=n Global This parameter sets the maximum number of LUNs
allowed during the LUN scan. The range of LUNs
searched is 0 to (n – 1).
/MAXLUNS parameter example:
LOAD QL2x00.HAM SLOT=3 /LUNS /MAXLUNS=256
Table 11-1. QL2300.HAM Driver Parameters (Continued)
Parameter Type Description