User`s guide

9 – Windows Server 2003 Driver Installation
Installing the Windows Server 2003 Driver
9-2 FC2354601-00 J
Q
9.3
Installing the Windows Server 2003 Driver
Perform the installation instructions that correspond to your system:
■
To install Windows Server 2003 and the Windows Server 2003 driver with the
QLA23xx HBA connected to the boot device, perform the installation procedures
in section 9.3.1.
■
To install Windows Server 2003 and the Windows Server 2003 driver with the
QLA23xx HBA connected to an add-on device, perform the installation
procedures in section 9.3.2.
■
To install the Windows Server 2003 driver when Windows Server 2003 is already
loaded on your system, perform the installation procedures in section 9.3.3.
■
To update the existing Windows Server 2003 driver, perform the installation
procedures in section 9.3.4.
9.3.1
Initial Installation of Windows Server 2003 and the Windows Server 2003
Driver (QLA23xx HBA Connects to the Boot Device)
Follow these steps to initially install Windows Server 2003 and the Windows Server
2003 driver with the QLA23xx HBA connected to the boot device:
1. Start the Windows Server 2003 installation using the Setup disks or CD-ROM
(CD) (if booting from a bootable CD-ROM drive) in an appropriate drive.
2. If you are booting from the CD, press F6 if you see the message Press F6 if
you want to install a third party SCSI or RAID Driver...
After all the standard devices have been loaded, press S to Specify Additional
Device. Go to step 5.
3. If you are booting from the Setup disks, after the standard devices have been
detected and configured, press S to Specify Additional Device.
4. Select Other and press ENTER.
5. Insert the QLogic disk created in section 9.2 and press ENTER.
6. Select the QLogic QLA23xx PCI Fibre Channel Adapter and press ENTER.
7. Continue with standard installation procedure.