User guide

3–InfiniBand
®
Cluster Setup and Administration
IB Bonding
IB0054606-02 A 3-9
Verify the following line is set to the value of yes in /etc/sysconfig/boot:
RUN_PARALLEL="yes"
Verify IB Bonding is Configured
After the configuration scripts are updated, and the service network is restarted or
a server reboot is accomplished, use the following CLI commands to verify that IB
bonding is configured.
 cat /proc/net/bonding/bond0
 # ifconfig
Example of cat /proc/net/bonding/bond0 output:
# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.2.3 (December 6, 2007)
Bonding Mode: fault-tolerance (active-backup) (fail_over_mac)
Primary Slave: ib0
Currently Active Slave: ib0
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: ib0
MII Status: up
Link Failure Count: 0
Permanent HW addr: 80:00:04:04:fe:80
Slave Interface: ib1
MII Status: up
Link Failure Count: 0
Permanent HW addr: 80:00:04:05:fe:80