User guide

G–Commands and Files
Summary and Descriptions of Useful Files
IB0054606-02 A G-35
This information is useful for reporting problems to Technical Support.
status_str
Check the file status_str to verify that the InfiniPath software is loaded and
functioning. The file is located here:
/sys/class/infiniband/qib/device/status_str
Table G-5 shows the possible contents of the file, with brief explanations of the
entries.
NOTE
This file returns information of where the form factor adapter is installed. The
PCIe half-height, short form factor is referred to as the QLE7140, QLE7240,
QLE7280, QLE7340, or QLE7342.
Table G-5. status_str File Contents
File Contents Description
Initted The driver has loaded and successfully initialized
the IBA6110 or IBA7220 ASIC.
Present The IBA6110 or IBA7220 ASIC has been detected
(but not initialized unless Initted is also present).
IB_link_up The IB link has been configured and is in the active
state; packets can be sent and received.
IB_configured The IB link has been configured. It may or may not
be up and usable.
NOIBcable Unable to detect link present. This problem can be
caused by one of the following problems with the
QLE7140, QLE7240, or QLE7280 adapters:
 No cable is plugged into the adapter.
 The adapter is connected to something other
than another IB device, or the connector is not
fully seated.
 The switch where the adapter is connected is
down.
Fatal_Hardware_Error Check the system log (default is /var/log/mes-
sages) for more information, then call Technical
Support.