User guide

G–Commands and Files
Summary and Descriptions of Commands
G-10 IB0054606-02 A
[ADAPTER]
PSID = MT_0D80120009
pcie_gen2_speed_supported = true
adapter_dev_id = 0x673c
silicon_rev = 0xb0
gpio_mode1 = 0x0
gpio_mode0 = 0x050e070f
gpio_default_val = 0x0502010f
[HCA]
hca_header_device_id = 0x673c
hca_header_subsystem_id = 0x0017
dpdp_en = true
eth_xfi_en = true
mdio_en_port1 = 0
[IB]
phy_type_port1 = XFI
phy_type_port2 = XFI
read_cable_params_port1_en = true
read_cable_params_port2_en = true
;;Polarity
eth_tx_lane_polarity_port1=0x0
eth_tx_lane_polarity_port2=0x0
eth_rx_lane_polarity_port1=0x1
eth_rx_lane_polarity_port2=0xD
;;Lane reversal
eth_tx_lane_reversal_port1=on
eth_tx_lane_reversal_port2=on
eth_rx_lane_reversal_port1=on
eth_rx_lane_reversal_port2=on
port1_sd0_ob_preemp_pre_qdr = 0x0
port2_sd0_ob_preemp_pre_qdr = 0x0
port1_sd1_ob_preemp_pre_qdr = 0x0
port2_sd1_ob_preemp_pre_qdr = 0x0