User guide

B–SRP Configuration
QLogic SRP Configuration
B-18 IB0054606-02 A
 The target device is discovered and configured through the appropriate FC
port
 The SRP Initiator is discovered and configured once for the proper
initiatorExtension.
 The SRP map created for the initiator connects to the same target
Configuring Fibre Channel Load Balancing
The following examples display typical scenarios for how to configure Fibre
Channel load balancing.
In the first example, traffic going to any Fibre Channel Target Device where both
ports of the VIO hardware card have a valid map, are split between the two ports
of the VIO hardware card. If one of the VIO hardware ports goes down, then all of
the traffic will go over the remaining port that is up.
1 Adapter Port and 2 Ports on a Single VIO
session
begin
card: 0
port: 1
targetIOCProfileIdString: "
FVIC in Chassis
0x00066A0050000123, Slot 1, IOC 1"
initiatorExtension: 3
end
session
begin
card: 0
port: 1
targetIOCProfileIdString: "
FVIC in Chassis
0x00066A0050000123, Slot 1, IOC 2"
initiatorExtension: 3
end
adapter
begin
description: "Test Device"
roundrobinmode: 1
end