User guide

B–SRP Configuration
QLogic SRP Configuration
IB0054606-02 A B-17
On the VIO hardware side, the following need to be ensured on each FVIC
involved in the failover:
 The target device is discovered and configured through the appropriate FC
port
 The SRP Initiator is discovered and configured once for the proper
initiatorExtension.
 The SRP map created for the initiator connects to the same target
Failover Configuration File 4: Failing over from a port on a
VIO hardware card to a port on a different VIO hardware
card in a different Virtual I/O chassis
session
begin
card: 0 (InfiniServ HCA card number)
port: 1 (InfiniServ HCA port number)
targetIOCProfileIdString: "FVIC in Chassis <FRUChassisGUID1>,
<Slot1>, <IOC>"
initiatorExtension: 1
end
session
begin
card: 0 (InfiniServ HCA card number)
port: 1 (InfiniServ HCA port number)
targetIOCProfileIdString: "FVIC in Chassis <FRUChassisGUID2>,
<Slot1>, <IOC>" (Chassis GUID differs to indicate a card in a
different chassis)
initiatorExtension:1 (Here the initiator extension can be the
same as in the previous definition, because the SRP map is
being defined on a different FC gateway card)
end
adapter
begin
description: “FC Port Failover”
end
On the VIO hardware side, the following need to be ensured on each FVIC
involved in the failover: