User guide

B–SRP Configuration
QLogic SRP Configuration
B-16 IB0054606-02 A
On the VIO hardware side, the following needs to be ensured:
 The target device is discovered and configured for each of the ports that is
involved in the failover.
 The SRP Initiator is discovered and configured once for each different
initiatorExtension.
 Each map should use a different Configured Device, e.g Configured Device
1 has the Target being discovered over FC Port 1, and Configured Device 2
has the Target being discovered over FC Port 2.)
Failover Configuration File 3: Failing over from a port on a
VIO hardware card to a port on a different VIO hardware card
within the same Virtual I/O chassis
session
begin
card: 0 (InfiniServ HCA card number)
port: 1 (InfiniServ HCA port number)
targetIOCProfileIdString: "FVIC in Chassis <FRUChassisGUID>,
<Slot1>, <IOC>"
initiatorExtension: 1
end
session
begin
card: 0 (InfiniServ HCA card number)
port: 1 (InfiniServ HCA port number)
targetIOCProfileIdString: "FVIC in Chassis <FRUChassisGUID>,
<Slot2>, <IOC>" (Slot number differs to indicate a different
VIO card)
initiatorExtension: 1 (Here the initiator extension can be the
same as in the previous definition, because the SRP map is
being defined on a different FC gateway card)
end
adapter
begin
description: “FC Port Failover”
end