User guide

B–SRP Configuration
QLogic SRP Configuration
B-14 IB0054606-02 A
Failover Configuration File 1: Failing over from one
SRP Initiator port to another
In this failover configuration file, the first session (using adapter Port 1) is used to
reach the SRP Target Port. If a problem is detected in this session (e.g., the IB
cable on port 1 of the adapter is pulled) then the 2nd session (using adapter Port
2) will be used.
# service 0: name SRP.T10:0000000000000001 id
0x0000494353535250
session
begin
card: 0
port: 1
#portGuid: 0x0002c903000010f1
initiatorExtension: 1
targetIOCGuid: 0x00066a01e0000149
targetIOCProfileIdString: "BC2FC in Chassis
0x0000000000000000, Slot 6, Ioc 1"
targetPortGid: 0xfe8000000000000000066a01e0000149
targetExtension: 0x0000000000000001
SID: 0x0000494353535250
IOClass: 0xff00
end
session
begin
card: 0
port: 2
#portGuid: 0x0002c903000010f2
initiatorExtension: 1
targetIOCGuid: 0x00066a01e0000149
targetIOCProfileIdString: "BC2FC in Chassis
0x0000000000000000, Slot 6, Ioc 1"
targetPortGid: 0xfe8000000000000000066a01e0000149
targetExtension: 0x0000000000000001
SID: 0x0000494353535250
IOClass: 0xff00
end
adapter
begin