User`s guide

3 – Event Messages
Alarm Events
59060-00 03 3-5
0
[A] [1003.0041] [Zoning objects which contain Fibre Channel (FC) Address Members not
being sent to remote switch on save, not supported in this mode]
Meaning: An attempt was made to assign a zone member by FC address
while Interop mode was disabled. When Interop mode is disabled,
zone membership must be defined by world wide name or
domain_ID and port number.
Action: Enable Interop mode or change the zone membership type.
[A] [1004.0001] [Port in active hard zone, but not installed or present on this switch.]
Meaning: A zone member in an ACL zone on this switch is defined with an
invalid port number.
Action: Examine the fabric and correct the zone membership.
[A] [1004.0005] [No communication from neighbor switch on port port_number with domain
ID domain_ID, lost route]
Meaning: This switch has not received a hello from the remote switch for 80
seconds. Discard routes learned through this link and renegotiate.
Action: None
[A] [1004.0008] [Eport Isolating due to ELP Incompatibility]
Meaning: An E_Port isolated due to an Exchange Link Parameter (ELP)
incompatibility.
Action: Review accompanying alarms for specific cause.
[A] [1004.0009] [Eport Isolating due to ESC Incompatibility]
Meaning: An E_Port isolated because the connecting switch failed to support
the standard routing protocol Fabric Shortest Path First (FSPF).
Action: Connect a compatible switch.
[A] [1004.000A] [Eport Isolating due to EFP Domain Overlap]
Meaning: An E_Port isolated because each fabric has a switch with the same
domain ID.
Action: Change the domain ID on one of the conflicting switches.
[A] [1004.000B] [Eport Isolating due to Switch Administratively Offline]
Meaning: An E_Port isolated because the local switch has been placed
offline.
Action: Configure the administrative state to Online to establish the link.