Installation guide

4 – Installation
Installing a Switch
59055-00 B 4-17
D
the SANbox Manager application. From a command line, you can enter the
SANbox_Manager command:
<install_directory>sanbox_manager.exe
 For a Linux platform, enter the SANbox_Manager command:
<install_directory>SANbox_Manager
 For a Solaris platform, enter the SANbox_Manager command:
<install_directory>SANbox_Manager
The application opens with the Initial Start dialog. Refer to the SANbox 5200
Switch Management User’s Guide for more information about using, exiting, and
uninstalling SANbox Manager.
4.2.7
Configure the Switch
You can configure the switch using the SANbox Manager application or the
command line interface. If you are using the command line interface, refer to
”Config Command” on page B-10 and ”Set Config Command” on page B-33. To
configure the switch using SANbox Manager, click the Open Configuration
Wizard radio button in the Initial Start dialog, then click the Proceed button. The
Configuration wizard explains and prompts you for the following information:
Refer to the SANbox 5200 Switch Management User’s Guide for more information
about configuring a switch.
Temporary IP address
Temporary subnet mask
Archive template file
Switch domain ID (1–-239)
Domain ID Lock (Locked/Unlocked)
Switch name
Permanent IP address
Permanent subnet mask
Permanent gateway address
Permanent network discovery method
Date and time
Admin account password
Create a configuration archive?