Installation guide

59055-00 B Page v
SANbox 5200 Fibre Channel Switch
Installation Guide
D
4.2 Installing a Switch............................................................................................... 4-2
4.2.1 Mount the Switch....................................................................................... 4-3
4.2.2 Install Transceivers.................................................................................... 4-5
4.2.3 Connect the Switch to AC Power .............................................................. 4-7
4.2.4 Connect the Management Workstation to the Switch............................... 4-9
4.2.4.1 Ethernet Connection....................................................................... 4-10
4.2.4.2 Serial Connection ........................................................................... 4-10
4.2.5 Install and Start SANbox Manager Using SANsurfer Management Suite 4-12
4.2.5.1 SANsurfer Management Suite Disk - Windows Installation ............ 4-12
4.2.5.2 SANsurfer Management Suite Disk - Linux Installation .................. 4-13
4.2.5.3 SANsurfer Management Suite Disk - Solaris Installation................ 4-14
4.2.5.4 Starting SANsurfer Management Suite........................................... 4-15
4.2.6 Install and Start SANbox Manager Using the SANbox Manager
Installation Disk ....................................................................................... 4-15
4.2.6.1 SANbox Manager Installation Disk - Windows Installation ............. 4-15
4.2.6.2 SANbox Manager Installation Disk - Linux Installation ................... 4-16
4.2.6.3 SANbox Manager Installation Disk - Solaris Installation................. 4-16
4.2.6.4 Starting SANbox Manager .............................................................. 4-16
4.2.7 Configure the Switch ............................................................................... 4-17
4.2.8 Cable Devices to the Switch.................................................................... 4-18
4.3 Install Firmware ................................................................................................ 4-18
4.3.1 Using SANbox Manager to Install Firmware............................................ 4-19
4.3.2 Using the CLI to Install Firmware ............................................................ 4-19
4.3.3 Using FTP and the CLI to Install Firmware.............................................. 4-20
4.4 Upgrading the SANbox 5200 Switch ................................................................ 4-22
4.5 Powering Down a Switch.................................................................................. 4-23
Section 5 Diagnostics/Troubleshooting
5.1 POST Diagnostics.............................................................................................. 5-1
5.1.1 Heartbeat LED Blink Patterns.................................................................... 5-2
5.1.1.1 Internal Firmware Failure Blink Pattern ............................................ 5-2
5.1.1.2 System Error Blink Pattern ............................................................... 5-2
5.1.1.3 Configuration File System Error Blink Pattern .................................. 5-3
5.1.1.4 Over Temperature Blink Pattern ....................................................... 5-5
5.1.2 Logged-In LED Indications ........................................................................ 5-6
5.1.2.1 E_Port Isolation ................................................................................ 5-7
5.1.2.2 Excessive Port Errors ....................................................................... 5-8
5.2 Chassis Diagnostics......................................................................................... 5-10
5.2.1 Input Power LED Is Extinguished............................................................ 5-10
5.2.2 System Fault LED is Illuminated.............................................................. 5-11