Product specifications

Switch Command Line Interface
Groups and Commands
1-28 D000103-000 E
This command can also be used to enable or disable various access methods. Use
'-<proto> 0' to disable a protocol, and '-<proto> 1' to enable. Multiple operations
may be specified in a single command.
A reboot is not required for this command. Depending on the specific method, it
may take 5-10 seconds for the changes. Note that existing connections (for example
a telnet session) will not be affected by disabling the underlying access method.
Any access method supported by the device (but not listed here) cannot be
configured and is always enabled.
genPost
Displays General POST results and runs tests
Syntax:
Options:
Sample Output:
NOTES: Displays General POST results and runs tests.
genPost
None.
MasterMM202-> genpost
ID Gen POST Name Result ENA DEM PWR Result-Ext
---------------------------------------------------------------------------
* POST TEST CPU NO-RUN Y N Y
* POST TEST MEM DRAM NO-RUN Y N Y
* POST TEST BOOTROM IMG CHKSUM NO-RUN Y N Y
* POST TEST RUN-TIME IMG CHKSUM NO-RUN Y N Y
* POST TEST JMP RAM NO-RUN Y N Y
6 POST TEST I2C PROBE NO-RUN Y Y N
7 POST TEST FAN TRAYS NO-RUN Y Y N
8 POST TEST PWR SUPPLIES NO-RUN Y Y N
9 POST TEST REAL-TIME CLOCK NO-RUN Y Y N
10 POST TEST PROTO NO-RUN Y Y N