Installation guide

1–Installation
Component LEDs
1-66 D000140-001 D
 The switch temperature is at a warning level on the module.
 The switch silicon temperature is at a warning level (approximately 90
degrees C).
 DC voltages on the board are slightly out of tolerance (12V Bulk, 5V,
3.3V and 1.8V are all monitored).
 The module can no longer function properly. The system will take the
appropriate actions to ensure that no damage is done to its
components.
 Blinking Amber (once every four seconds) - LED test state.
SEEB Module
Figure 1-58. SEEB Module LEDs
RJ45 LEDs
The RJ45 connectors have two LEDs, Act and 100. The 100 LED is Green when
a 100Mbps link is connected. The Act LED is Amber when an Ethernet link has
been established, and blinking when the link is active.
MRL Active
The MRL Active LED is Green when the mechanical release latch (MRL)
thumbsrew is secured to the Serial, Ethernet, Chassis EEPROM Board (SEEB)
and a Management Module is installed in the front of the chassis.